Look no further if you’re thinking about having your concrete surface pressure washed, soft washed, coated and/or sealed. Whether it’s your pool deck, sidewalk, driveway, pool coping, tile grout, seawall, or stucco home, just a one-time application of Splash Proof’s nanotechnology coating is adequately procedural. Splash Proof’s revolutionary product line of nanotechnology coating facilitates a super-hydrophobic layer to shield and protect your concrete surface from muggy environmental damages.
Splash Proof is a nanotechnology coating company that offers one-stop-solution of protection from regrowth of mold and mildew that sits stubbornly on concrete surface spanning across residential or commercial properties. Splash Proof’s nanotechnology coating dries clear, non-slippery and gives an additional benefit of 5-year warranty on all ground work performed by certified Splash Proof technicians.
After Splash Proof is contacted for a service, certified technicians get into action to start off the cleaning, coating, and sealing process.
Day 1 – A certified technician examines and evaluates the area to determine the kind of stain removal is required on the surface. Next, the team begins to prepare the surface with a sanitizing and cleaning solution to remove any contamination spread on surfaces such as stains, dirt, mold and or mildew, followed by the process of pressure washing or soft washing. Afterwards, necessary water rinsing of the area is done to clean and clear away deposits of detergents or acids, if any, that were used earlier. The next step is to allow the surface to dry completely leaving it for at least 24 hours.
Day 2 - Prior to the Splash Proof application on the concrete surface, the certified technician inspects to determine if the concrete surface is dry to the touch. Upon certifying, the team begins coating the concrete surface with Splash Proof's Nanotechnology coating, using either SP-21S solvent based or water-based SP-21W products.
Splash Proof normally dries in sunny areas within 2-3 hours but it requires nearly 24-36 hours for curing. Shaded areas, low temperatures, or higher humidity slow down the drying process. The surface may be kept open to foot traffic in 2-3 hours and to vehicular traffic in 24-36 hours. Splash Proof recommends all sprinkler systems be turned off during this time to allow proper curing.
Splash Proof is a protectant that layers your concrete with super hydrophobic coating thereby reducing mold and mildew. Periodic washing with plain water to keep the area clean is recommended. Acids, gasoline, hydraulic fluids, and motor oil spills need to be removed from the surface as soon as possible.